DT-AVR AT90USB162 CPU Module

Specifications :

• Based on AT90USB162 (16KB Flash Memory, 512Byte EEPROM, & 512 Byte Internal SRAM).

  • One 8-bit Timer/Counter (2 PWM) and one 16-bit Timer/Counter (3 PWM).

  • Interface : USART, SPI, USB Device.

  • Watchdog timer, analog comparator.

• 22 I/O.

• 8MHz crystal oscillator.

• Downloading code through ISP Port or mini USB Port (using bootloader).

• Downloading code through USB Port (using bootloader) does not need additional programmer device, such as DT-HiQ AVR In System Programmer, DT-HiQ AVR USB ISP or DT-HiQ AVR-51 USB ISP.

• Uses FLIP software on PC to downloading code on microcontroler through USB Port.

• Downloading code through ISP Port using DT-HiQ AVR In System Programmer, DT-HiQ AVR USB ISP or DT-HiQ AVR-51 USB ISP will delete the bootloader code on microcontroller, so bootloader feature can not be used.

• Equipped with EMI filter chip to minimize noise from power supply.

• 3,3VDC – 5,5VDC Power Supply

• Power Supply through Bus Power (USB) or 5VDCexternal Power Supply.

• Comes with jumper to choose power supply source and voltage of power supply.

• PORTC.0 can be used as I/O or connected to the crystal oscillator by jumper selection.

• This module will be more easy to use if connected to the DT-COMBO BASIC BASE BOARD.

Includes :

• 1x DT-AVR AT90USB162 CPU Module board.

• USB Cable.

• 1x DVD consist of manual, circuit schematic, testing procedure , supported software, and Innovative Electronics offline website.