ROBOTIS

Humanoid robot kit with built-in PC as main controller, HD camera, and other sensors (gyro, accelerometer, microphone, etc.). This robot is suitable for...

Robotis GP Humanoid Robot Kit

18 DoF (Degree of Freedom) robot kit. This robot kit is well suited for soccer competition.

A tool to help you to remove rivet which is attached on OLLO robot kit.

OLLO Dual Bracket-S white 5pcs

A set of colorful rivet for OLLO robot kit.

OLLO Rivet Box ORB-20

Switch for OLLO robot kit which can be used to connect battery box with geared motor box.

OLLO Battery Box OBB-10A

Recomended Li-Po battery for Bioloid Premium Kit.

LIPO Battery Charger LBC-10

USB downloader for some of controller module from Robotis.

SMPS 12V 5A PS-10 [EU-220V]

Power supply converter board for Dynamixel series.

Little Fuse 125V 10A (LFU-10) 10pcs

Optional kit for DARwIn-OP. This kit comes with FSR (Force-Sensing Resistor) to detect down force for each foot.

DMS-80

Touch sensor for OLLO robot kit. You can use this sensor as bump detector for your robot.

OLLO IR Sensor OIS-10

Gyro sensor which can be used to keep the robot balance.

OLLO IR Receiver OIR-10

A set of gripper frame which is compatible with BIOLOID GP robot kit or DYNAMIXEL (AX-series)

OLLO Servo Motor OSM-10

Geared DC motor for OLLO robot kit.

Gear set for MX-28.

AX-18A Gear Set

Gear set for AX-12+/12A/18F/18A.

OLLO LED Module OLM-10

Use this cable to connect 3P sensors with GP I/O port of your controller module.

Robot Cable-3P 200mm 10pcs

3 pin cables for Dynamixel (AX series).

BIOLOID Skin FP04-F56/F57/F58/F59 Set

Serial cable for CM-5, CM-510, and CM-2+.

USB2Dynamixel

a pair of modules for bluetooth communication between robots.

ZIG2Serial

ZIG-100 Set

Remote controller for controlling OLLO or BIOLOID robot kit through wireless communication.

CM-700

Controller module based on ARM Cortex STM32F103RE which can be used to control AX/MX series Dynamixel.

CM-510

CM-5

Smart servo with internal controller. This servo comes with UART TTL (multi drop) interface, PID controller, and up to 3 Mbps communication speed.

Dynamixel EX-106+ Robot Actuator

Smart servo with internal controller. This servo comes with RS-485 (multi drop) interface and up to 64 kgf.cm torque.

DYNAMIXEL RX-28 HN07-N101 Type / DYNAMIXEL RX-28 HN07-N1 Type

Smart servo with internal controller. This servo comes with RS-485 (multi drop) interface and up to 26 kgf.cm torque.

DYNAMIXEL AX-18A

All in one sensor module which comes with UART TTL (multi drop) interface.

DYNAMIXEL AX-12W

Smart servo with internal controller. This servo comes with UART TTL (multi drop) interface and up to 15 kgf.cm torque

Additional kits for OLLO Explorer Kit. You can add this kit to your OLLO Explorer Kit so it has the same parts as OLLO Inventor Kit.

ROBOTIS OLLO Bug Kit (Motors, Sensors, Remote)

Robot kit which can be built into various kinds of forms.

DW-EK01 Electronic Parts for DARwin-OP Robot

4 DoF robot kit which is suitable for beginner to start learning robotics.

Bioloid Comprehensive Robot Kit

18 DoF (Degree of Freedom) robot kit. This robot kit is well suited for soccer competition.

Bioloid Expert Kit

Bioloid GP Humanoid Robot Kit

Humanoid robot kit with built-in PC as main controller, HD camera, and other sensors (gyro, accelerometer, microphone, etc.). This robot is suitable for...

ROBOTIS OLLO Figure (non-motorized)

A robot kit which can be built into various forms. This kit is suitable for kids to start learning robotics.

ROBOTIS OLLO Explorer Kit

OLLO Inventor Kit

Controller module for OLLO robot kit. This module based on ATmega8 microcontroller.

Communication module which operated on 2.4 GHz.